This document contains the setup steps for the Omma application without going to the field. These steps consist of two different applications and how they are performed:
New devices or devices ready for setup after a factory reset.
Devices controlled with the LG SuperSign CMS application.
At the end of the document, tasks to be performed after the setups are completed are listed as links.
If you have any questions, you can reach us at [email protected]
Thank you.
Omma Remote Installation Requirements
This document explains the ongoing scenarios for "Remote Installation of the Omma Application." Two scenarios will be covered:
Pre-installation Requirements
For Beanstaller:
Devices must be at the "Ready to Use" screen, either during the initial setup out of the box or after a factory reset.
The Beanstaller application must be installed on a Windows, Mac, or Linux device to access the target device.
The device running the Beanstaller application and the devices to install the Omma application must be on the same network.
Once these conditions are met, follow the steps on the "Beanstaller Installation" page to install the Omma application on your device.
For Supersign:
The devices must be managed through the Supersign application.
The user managing the devices via Supersign must have Admin privileges.
After ensuring these conditions are met, connect to the server managing the devices via Supersign and follow the steps outlined in the "Supersign Installation" guide.